|These map light button covers ared sold as a pair, they are
made from quality 6061 T6 Billet Aluminum, precision machined, then decorative polished and triple chromed. Sold in GT version or Smooth. Simply a stunning product that is noticed immediately!|
Installation is very easy. Clean the intended location area with soap and water to remove any grime that may cause poor bond. Set into place to review fit and location. Remove the backer from the 3M tape on the back of the part. Lightly set into place, review location and upon being satisfied with it, press down to adhere. Part will hold immediately, but will take 24 hours to reach full bond. We use high quality 3M tape that will reach very high final bond strength.